GE Washer E23 Error Code
Washer overfilled. Here is what it means and how to clear it, easiest fix first.
The control sensed more water in the tub than it should hold. Either the water inlet valve is not closing fully, or the water level sensor is giving a false reading.
Front-load fault code. On some older GE Profile front-loaders the same number is listed as a drive motor fault instead.
How to fix GE E23
Cut power and water
Turn off both faucets right away. Unplug the washer, unless water has reached the outlet or cord; in that case switch off its breaker instead. Then wipe up any water on the floor.
Watch for creeping water
With the washer still unplugged, briefly turn the faucets back on and watch the drum for a few minutes, ready to shut them off. If water keeps trickling in with no power, the inlet valve is stuck open; leave the faucets off until it is replaced.
Note whether the tub is empty
If the code appears when the drum is empty or barely wet, the water level sensor or its hose is the more likely cause. Write this down for the technician or parts search.
When to call a technician
Call a technician if the valve leaks with power off or the code appears with an empty tub, since replacing the valve or level sensor means opening the cabinet.
Parts that commonly cause E23
- Water inlet valve assembly
- Water level sensor
Order parts by your exact model number so they fit.
Other GE washer codes
- H2O SUPPLYWasher is not getting water
- E22Fill took too long
- E30Washer will not drain
- E31Draining took too long
- PoSlow drain (top-load)
- SudToo many suds
- UELoad is unbalanced
- dELid is open
- Lid LockedOpen the lid to start a new cycle
- doorDoor not closed or needs opening
- E60Door lock fault
- E38Dispenser system error
- E42Drive motor overloaded
- FEWater level too high
- CAnCELEdCycle was canceled
Frequently asked questions
What does E23 mean on a GE washer?
The control sensed more water in the tub than it should hold. Either the water inlet valve is not closing fully, or the water level sensor is giving a false reading.
Can I fix GE E23 myself?
Only the basic checks. You can safely try the steps above, but E23 usually points to a part or fault that needs a technician.
What if E23 keeps coming back?
A code that returns after a reset and the checks above usually means a part is wearing out. Note when E23 appears (which cycle, how often) and have your model number ready; it helps a technician bring the right part on the first visit.
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.