Home › Frigidaire › Washers › E41
Frigidaire Washer E41 Error Code
Door or lid reads as open on Frigidaire washers.
FrigidaireAll Frigidaire washer codes
The control reads the door (front-load) or lid (top-load) as open, so it won't start or carry on. Often it isn't fully closed or something is caught in it. Less often the switch or its wiring has failed.
Compatible models
Frigidaire front-loaders, including the FAFW4011LB, FAFW4221 and Affinity ATF7000FE. Top-loaders such as the FFTW4120SW use E3 for an open lid.
Also shown as
Many newer top-load models show E3 when the lid is open.
Difficulty
Most people can clear this one at home with simple checks.
Not sure you are reading the code right? See how to read Frigidaire washer codes.
How to fix Frigidaire E41
Close the door or lid firmly
Open it, check for clothing caught in the door seal or under the lid, and close it again until it latches.
Look for damage
Check the door latch or lid strike for cracks or bent parts.
Clear it with a reset
Give it the standard 5-minute power cut, then try a quick cycle.
When to call a technician
Door or lid clearly shut and E41 still there: the door lock or lid lock assembly, its wiring or the control may be at fault. Call a technician.
Parts linked to E41
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
- Door lock assembly
- Lid lock assembly
- Wire harness
Order parts by your full model number so they fit.
Frequently asked questions
Which Frigidaire models show the E41 code?
Frigidaire front-loaders, including the FAFW4011LB, FAFW4221 and Affinity ATF7000FE. Top-loaders such as the FFTW4120SW use E3 for an open lid.
Can I fix Frigidaire E41 myself?
Usually, yes. Most E41 problems clear with simple checks you can do at home. Start with the first step above: close the door or lid firmly.
Other Frigidaire washer codes
- E11Washer is taking too long to fill
- E21Washer is draining too slowly
- EF1Drain pump is clogged
- EF2Too many suds
- E13Water or air leak detected
- E31Pressure sensor not reporting
- E35Overfill detected
- E48Door lock circuit fault
- E52Drive motor or speed signal fault
- E5AMotor control board overheating or not communicating
- E68Water heater fault
- E75Water temperature sensor fault
- E91Control panel communication fault
- EA2Power supply out of range
- EF8Button stuck
- E4Top-loader out of balance
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.