Home › Frigidaire › Washers › EF1
Frigidaire Washer EF1 Error Code
Drain pump is clogged on Frigidaire washers.
FrigidaireAll Frigidaire washer codes
The control thinks the drain pump is blocked. Socks, coins, hairpins or a buildup of lint are the usual culprits.
Compatible models
Listed on Frigidaire front-load tech sheets, including the FAFW4011LB and FAFW4221LB/LW and the Affinity ATF7000FE.
Also shown as
Compare with E21, which is a slow drain in general.
Difficulty
Start with the safe checks below; a worn part may need replacing.
Not sure you are reading the code right? See how to read Frigidaire washer codes.
How to fix Frigidaire EF1
Unplug and prepare
Unplug the washer, lay towels and a shallow pan in front of it, and wait for any hot water to cool.
Clear the blockage
If your model has a pump filter or access cover (your manual shows where), open it slowly to let the water out, remove the debris and close it firmly. Check the drain hose for clogs as well.
Test a drain
Plug back in and run Drain & Spin.
When to call a technician
If you can't reach the pump on your model, or it still won't move water after clearing it, have a technician inspect or replace the drain pump.
Parts linked to EF1
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
- Drain pump
- Drain hose
Order parts by your full model number so they fit.
Frequently asked questions
Which Frigidaire models show the EF1 code?
Listed on Frigidaire front-load tech sheets, including the FAFW4011LB and FAFW4221LB/LW and the Affinity ATF7000FE.
Can I fix Frigidaire EF1 myself?
Often. The first steps above are safe checks a homeowner can do. If they don't clear EF1, the cause is likely a worn part that needs replacing.
Other Frigidaire washer codes
- E11Washer is taking too long to fill
- E21Washer is draining too slowly
- EF2Too many suds
- E13Water or air leak detected
- E31Pressure sensor not reporting
- E35Overfill detected
- E41Door or lid reads as open
- E48Door lock circuit fault
- E52Drive motor or speed signal fault
- E5AMotor control board overheating or not communicating
- E68Water heater fault
- E75Water temperature sensor fault
- E91Control panel communication fault
- EA2Power supply out of range
- EF8Button stuck
- E4Top-loader out of balance
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.