Home › Frigidaire › Washers › E4
Frigidaire Washer E4 Error Code
Top-loader out of balance on Frigidaire washers.
FrigidaireAll Frigidaire washer codes
On Frigidaire top-loaders, E4 means the load went out of balance during spin. An uneven load, a washer that isn't level, or shipping foam left in place is the usual cause.
Compatible models
Frigidaire top-load washers such as the FFTW4120SW, whose owner's manual lists it.
Also shown as
Front-load models use different codes.
Difficulty
Most people can clear this one at home with simple checks.
Not sure you are reading the code right? See how to read Frigidaire washer codes.
How to fix Frigidaire E4
Redistribute the load
Stop the washer, wait for the lid to unlock, and spread the clothes evenly around the basket. Close the lid and restart.
Level the washer
All four feet should be firm on the floor. Adjust the leveling legs if the washer rocks.
Remove shipping supports
On a newly installed washer, check that the foam shipping support has been taken out, following your manual.
When to call a technician
Balanced loads still triggering E4 mean a technician should check the suspension.
Parts linked to E4
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
- Suspension rods
- Leveling legs
Order parts by your full model number so they fit.
Frequently asked questions
Which Frigidaire models show the E4 code?
Frigidaire top-load washers such as the FFTW4120SW, whose owner's manual lists it.
Can I fix Frigidaire E4 myself?
Usually, yes. Most E4 problems clear with simple checks you can do at home. Start with the first step above: redistribute the load.
Other Frigidaire washer codes
- E11Washer is taking too long to fill
- E21Washer is draining too slowly
- EF1Drain pump is clogged
- EF2Too many suds
- E13Water or air leak detected
- E31Pressure sensor not reporting
- E35Overfill detected
- E41Door or lid reads as open
- E48Door lock circuit fault
- E52Drive motor or speed signal fault
- E5AMotor control board overheating or not communicating
- E68Water heater fault
- E75Water temperature sensor fault
- E91Control panel communication fault
- EA2Power supply out of range
- EF8Button stuck
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.