Kenmore Dryer E24 / E25 Error Code

Temperature sensor fault on 417 dryers on Kenmore dryers.

E24 / E25

Moderate DIY

On a 417 dryer, E24 and E25 flag a failed thermistor. The control relies on it to keep the heat in range. Sears PartsDirect's fix is to check the sensor and replace it if it's bad.

Compatible models

Kenmore 417 model dryers, per Sears PartsDirect.

Also shown as

No other codes are listed for this fault.

Difficulty

Start with the safe checks below; a worn part may need replacing.

How to fix
When to call a pro
Parts
FAQ

Not sure you are reading the code right? See how to read Kenmore dryer codes.

Safety first: unplug the dryer (or switch off its breaker) before touching filters, hoses or panels. If you smell burning or gas, or see water near the outlet, stop and call a professional.

How to fix Kenmore E24 / E25

Reset first
Cut power at the plug for a few minutes. Once it's back on, a heated cycle will show whether E24 or E25 returns.
Note the exact code
Write down whether it's E24 or E25 and your full model number before booking a repair or ordering a part.

When to call a technician

Sears PartsDirect gives about 50,000 ohms as a healthy reading. A technician can measure the thermistor with the dryer unplugged and fit a new one if it's out of range.

Parts linked to E24 / E25

These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.

Thermistor (temperature sensor)

Order parts by your full model number so they fit.

Step-by-step guides for this problem

DryerTroubleshootingDryer Overheating or Shutting Off Mid-Cycle? Causes and Fixes
A dryer that runs too hot or shuts off partway through a cycle almost always has an airflow problem: a packed lint screen, a crushed or overlong duct, or an outside hood that won't open.
7 min readRead guide

Frequently asked questions

Which Kenmore models show the E24 / E25 code?

Kenmore 417 model dryers, per Sears PartsDirect.

Can I fix Kenmore E24 / E25 myself?

Often. The first steps above are safe checks a homeowner can do. If they don't clear E24 / E25, the cause is likely a worn part that needs replacing.

Other Kenmore dryer codes

Last reviewed 2026-10-21. Codes and steps can vary by model; check your owner's manual.

Sources we checked

www.searspartsdirect.com