Home › Dishwashers › Whirlpool › F1E1
Whirlpool Dishwasher F1E1 Error Code
Control board fault. Here is what it means and how to clear it, easiest fix first.
Whirlpool lists the control module (main control board) as the likely cause. An older Sears PartsDirect table describes it more specifically as a stuck relay on the board. A reset may clear it; otherwise the board needs service.
On models without a digital display, the Clean light shows this as 1 quick flash, a short pause, then 1 flash, repeating after a longer pause.
How to fix Whirlpool F1E1
Reset the control
Unplug the dishwasher for 30 seconds, then plug it back in. If it is hard-wired, switch off its breaker at the electrical panel for 30 seconds instead, then switch it back on and try a cycle.
Note the code and model number
Write down the exact code, when in the cycle it appeared, and the model and serial numbers from the rating label (usually on the side or top edge of the door or tub). With nothing safe left to check yourself, this lets the technician bring the right part on the first visit.
When to call a technician
If F1E1 returns after a reset, schedule service.
Parts that commonly cause F1E1
- control board
- wiring harness
Order parts by your exact model number so they fit.
Other Whirlpool dishwasher codes
- F9E1Long drain (slow or no drain)
- F9E2Drain motor error
- F8E1 / H2ONo water detected
- F8E2Fill valve electrical error
- F8E4Water in the drip tray
- F8E5Fill valve stuck open
- F6E3Too many suds
- F6E4Water float switch fault
- F7E2Wash motor error
- F4E2 / F4E3Heating error
- F3E2Temperature or soil sensor fault
- F6E1Control panel or main control error
- F1E2 / F2E2Control communication error
- F2E1Stuck button or console error
- FAE4 / F10E4Diverter valve error
- FAE5 / F10E5Diverter leak
- Sanitize light flashingLoad was not sanitized
- Control lock light blinks 3 timesControls are locked
- All cycle and option lights flashingCycle paused (door opened)
Frequently asked questions
What does F1E1 mean on a Whirlpool dishwasher?
Whirlpool lists the control module (main control board) as the likely cause. An older Sears PartsDirect table describes it more specifically as a stuck relay on the board. A reset may clear it; otherwise the board needs service.
Can I fix Whirlpool F1E1 myself?
Only the basic checks. You can safely try the steps above, but F1E1 usually points to a part or fault that needs a technician.
What if F1E1 keeps coming back?
A code that returns after a reset and the checks above usually means a part is wearing out. Note when F1E1 appears (which cycle, how often) and have your model number ready; it helps a technician bring the right part on the first visit.
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.