Home › Dishwashers › Whirlpool › F8E2
Whirlpool Dishwasher F8E2 Error Code
Fill valve electrical error. Here is what it means and how to clear it, easiest fix first.
The control has found an electrical problem with the water inlet (fill) valve. A loose connection or a failed valve coil is the likely cause.
On models without a digital display, the Clean light shows this as 8 quick flashes, a short pause, then 2 flashes, repeating after a longer pause. Whirlpool's current pages call this a fill valve electrical error; an older Sears PartsDirect code table lists it as a drain pump electrical problem, which may apply to some older models. Check your owner's manual or tech sheet for your model.
How to fix Whirlpool F8E2
Look for leaks at the valve
Turn off the dishwasher's water supply and switch off its breaker (or unplug it if the plug is dry and away from any water). Remove the toe kick panel, pull out the drip tray and look for water around the inlet valve connection. Dry anything you find and note where it came from.
Reset the control
Unplug the dishwasher for 30 seconds, then plug it back in. If it is hard-wired, switch off its breaker at the electrical panel for 30 seconds instead, then switch it back on and try a cycle.
When to call a technician
If F8E2 returns after a reset, schedule service to test the inlet valve and its wiring.
Parts that commonly cause F8E2
- water inlet valve
- wire harness
Order parts by your exact model number so they fit.
Other Whirlpool dishwasher codes
- F9E1Long drain (slow or no drain)
- F9E2Drain motor error
- F8E1 / H2ONo water detected
- F8E4Water in the drip tray
- F8E5Fill valve stuck open
- F6E3Too many suds
- F6E4Water float switch fault
- F7E2Wash motor error
- F4E2 / F4E3Heating error
- F3E2Temperature or soil sensor fault
- F6E1Control panel or main control error
- F1E1Control board fault
- F1E2 / F2E2Control communication error
- F2E1Stuck button or console error
- FAE4 / F10E4Diverter valve error
- FAE5 / F10E5Diverter leak
- Sanitize light flashingLoad was not sanitized
- Control lock light blinks 3 timesControls are locked
- All cycle and option lights flashingCycle paused (door opened)
Frequently asked questions
What does F8E2 mean on a Whirlpool dishwasher?
The control has found an electrical problem with the water inlet (fill) valve. A loose connection or a failed valve coil is the likely cause.
Can I fix Whirlpool F8E2 myself?
Only the basic checks. You can safely try the steps above, but F8E2 usually points to a part or fault that needs a technician.
What if F8E2 keeps coming back?
A code that returns after a reset and the checks above usually means a part is wearing out. Note when F8E2 appears (which cycle, how often) and have your model number ready; it helps a technician bring the right part on the first visit.
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.