Amana Washer LoC Error Code
Control Lock is on on Amana washers.
Nothing is broken here. Control Lock is on, so the buttons ignore presses. It usually gets switched on by accident, or on purpose to keep kids off the panel.
Compatible models
Amana front-loaders that have a Control Lock button; whether you see LoC or LC depends on the model.
Also shown as
Depending on the model the display shows LoC or LC. While locked you can still press Start to pause or Power to turn the washer off.
Difficulty
Most people can clear this one at home with simple checks.
Not sure you are reading the code right? See how to read Amana washer codes.
How to fix Amana LoC
Hold the Control Lock button
Press and hold Control Lock for 3 seconds. The display counts 3, 2, 1 and then shows LoC or LC as the lock switches.
Check the controls
The buttons respond again once it unlocks. To lock the panel later, hold the same button for 3 seconds.
When to call a technician
Holding Control Lock for 3 seconds doesn't free the panel: contact Amana service.
Step-by-step guides for this problem
Frequently asked questions
Which Amana models show the LoC code?
Amana front-loaders that have a Control Lock button; whether you see LoC or LC depends on the model.
Can I fix Amana LoC myself?
Usually, yes. Most LoC problems clear with simple checks you can do at home. Start with the first step above: hold the control lock button.
Other Amana washer codes
- F9 E1Washer is taking too long to drain
- F8 E1Not enough water coming in
- F20No water or too little water
- F21Drain problem
- F5 E1Door switch problem
- F5 E2Door won't lock
- F7 E1Motor can't reach cycle speed
- F8 E2Dispenser system problem
- F8 E3Too much water or foam
- F0 E2Too many suds in the drum
- F0 E1Clothes in the drum during Clean Washer
- ErrChange not allowed right now
- IntCycle was paused or canceled
- FdSettings returned to factory defaults
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.