Home › Amana › Washers › F8 E3
Amana Washer F8 E3 Error Code
Too much water or foam on Amana washers.
Too much water or too much foam is in the tub, which Amana treats as an overflow. Regular (non-HE) detergent, too much HE detergent, very soft water and thickened "no splash" bleach all whip up extra suds.
Compatible models
Amana front-load models. Amana doesn't list which ones; your owner's manual will.
Also shown as
No other codes are listed for this fault.
Difficulty
Most people can clear this one at home with simple checks.
Not sure you are reading the code right? See how to read Amana washer codes.
How to fix Amana F8 E3
Check the floor
If water has spilled near the outlet or cord, switch off the breaker before you touch the plug.
Cut back the detergent
Use HE detergent only and measure it. With soft water you'll often need less than the bottle suggests.
Switch bleach
If you use "no splash" or "easy pour" chlorine bleach, change to regular liquid bleach. The thickener in those foams up.
Run Clean Washer and reset
Run a Clean Washer cycle to strip out detergent buildup, then do the 5-minute power reset before the next load.
When to call a technician
If you're using the right detergent and the code still shows, or water actually rises above normal, stop using the washer and book an Amana service visit.
Frequently asked questions
Which Amana models show the F8 E3 code?
Amana front-load models. Amana doesn't list which ones; your owner's manual will.
Can I fix Amana F8 E3 myself?
Usually, yes. Most F8 E3 problems clear with simple checks you can do at home. Start with the first step above: check the floor.
Other Amana washer codes
- F9 E1Washer is taking too long to drain
- F8 E1Not enough water coming in
- F20No water or too little water
- F21Drain problem
- F5 E1Door switch problem
- F5 E2Door won't lock
- F7 E1Motor can't reach cycle speed
- F8 E2Dispenser system problem
- F0 E2Too many suds in the drum
- F0 E1Clothes in the drum during Clean Washer
- ErrChange not allowed right now
- IntCycle was paused or canceled
- LoCControl Lock is on
- FdSettings returned to factory defaults
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.