Amana Washer F21 Error Code
Drain problem on Amana washers.
The washer flagged a drain problem. Amana's checks start at the drain hose: look for a kink or a clog.
Compatible models
Shown on Amana front-loaders. Amana's article doesn't narrow it to particular models.
Also shown as
No other codes are listed for this fault.
Difficulty
Most people can clear this one at home with simple checks.
Not sure you are reading the code right? See how to read Amana washer codes.
How to fix Amana F21
Unplug and check for kinks
Unplug the washer, pull it out from the wall a little and check that the drain hose isn't folded or crushed behind it.
Clear a clogged hose
With a bucket ready, lift the hose out of the standpipe and look for lint or a small sock jammed in the end. Run water through it at a laundry sink if it seems blocked.
Reset the control
Plug the washer back in once it's been unplugged for 5 minutes, then run a drain or spin cycle and watch that the water goes out.
When to call a technician
A clear hose and a washer that still won't empty points to the drain pump or a blockage inside the cabinet. That's a technician job.
Parts linked to F21
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Step-by-step guides for this problem
Frequently asked questions
Which Amana models show the F21 code?
Shown on Amana front-loaders. Amana's article doesn't narrow it to particular models.
Can I fix Amana F21 myself?
Usually, yes. Most F21 problems clear with simple checks you can do at home. Start with the first step above: unplug and check for kinks.
Other Amana washer codes
- F9 E1Washer is taking too long to drain
- F8 E1Not enough water coming in
- F20No water or too little water
- F5 E1Door switch problem
- F5 E2Door won't lock
- F7 E1Motor can't reach cycle speed
- F8 E2Dispenser system problem
- F8 E3Too much water or foam
- F0 E2Too many suds in the drum
- F0 E1Clothes in the drum during Clean Washer
- ErrChange not allowed right now
- IntCycle was paused or canceled
- LoCControl Lock is on
- FdSettings returned to factory defaults
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.