Home › Dryers › Whirlpool › F2E4 / F2E5
Whirlpool Dryer F2E4 / F2E5 Error Code
Control panel (user interface) fault. Here is what it means and how to clear it, easiest fix first.
The control panel that you press and read has reported an internal problem. Sears PartsDirect describes these as a user interface software error, and Whirlpool says the user interface or its wiring may be at fault. A reset sometimes clears a one-time glitch.
Maytag Centennial dryers also use F2 E4 and F2 E5. Older Duet dryers show F:72 through F:78 for a user interface assembly failure.
How to fix Whirlpool F2E4 / F2E5
Reset the dryer
Switch off the dryer's breaker(s), or unplug it, for 1 minute. Restore power, start a Timed Dry cycle, and watch for about 1 minute to see if the code comes back.
Note when it happens
If the code returns, write down the exact code and when it appears, and find your model number (usually on a label inside the door frame). This helps a technician bring the right part.
When to call a technician
A code that returns after a reset usually means the user interface board needs replacing. That involves opening the control panel, so leave it to a technician.
Parts that commonly cause F2E4 / F2E5
- User interface control board
- Wire harness
Order parts by your exact model number so they fit.
Other Whirlpool dryer codes
- AF / F4E3Restricted airflow: lint screen or vent blocked
- PFPower was interrupted during the cycle
- L2 / F4E4Low or missing supply voltage (electric dryers)
- ERRDoor not fully closed and latched
- LocControl lock is turned on
- F3E2Moisture sensor not reading the load
- F2E1Stuck button on the control panel
- F1E1Main control board fault
- F3E1Exhaust temperature sensor (thermistor) fault
- F3E3Inlet temperature sensor (thermistor) fault
- F4E1 / F4E2Heater system or heater relay fault
- F6E1 / F6E2 / F6E3Communication error between control boards
- F7E1Drive motor system fault
- E1 / E2Temperature sensor fault (older electronic models)
Frequently asked questions
What does F2E4 / F2E5 mean on a Whirlpool dryer?
The control panel that you press and read has reported an internal problem. Sears PartsDirect describes these as a user interface software error, and Whirlpool says the user interface or its wiring may be at fault. A reset sometimes clears a one-time glitch.
Can I fix Whirlpool F2E4 / F2E5 myself?
Only the basic checks. You can safely try the steps above, but F2E4 / F2E5 usually points to a part or fault that needs a technician.
What if F2E4 / F2E5 keeps coming back?
A code that returns after a reset and the checks above usually means a part is wearing out. Note when F2E4 / F2E5 appears (which cycle, how often) and have your model number ready; it helps a technician bring the right part on the first visit.
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.