Home › KitchenAid › Dishwashers › FAE4 / F10E4
KitchenAid Dishwasher FAE4 / F10E4 Error Code
Diverter valve error on KitchenAid dishwashers.
KitchenAidAll KitchenAid dishwasher codes
The diverter, which switches water between the lower and upper spray arms, isn't working as the control expects. KitchenAid gives no cause beyond the valve itself.
Compatible models
Shown by KitchenAid dishwashers that have a diverter between spray arms; KitchenAid doesn't name models.
Also shown as
KitchenAid treats FAE4 and F10E4 as the same code; the A stands in for 10.
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read KitchenAid dishwasher codes.
How to fix KitchenAid FAE4 / F10E4
Kill the power briefly
Half a minute without power, then switch back on.
Run a cycle
Start a normal wash and see whether the code returns partway through.
When to call a technician
If the code returns, book service. The diverter valve and its motor are inside the machine and need a technician.
Parts linked to FAE4 / F10E4
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
- diverter assembly
- diverter motor
Order parts by your full model number so they fit.
Step-by-step guides for this problem
Frequently asked questions
Which KitchenAid models show the FAE4 / F10E4 code?
Shown by KitchenAid dishwashers that have a diverter between spray arms; KitchenAid doesn't name models.
Can I fix KitchenAid FAE4 / F10E4 myself?
Only the basic checks. You can safely try the steps above, but FAE4 / F10E4 usually points to a part or fault that needs a technician.
Other KitchenAid dishwasher codes
- F9E1Long drain (water not pumping out)
- F9E2Drain motor error
- F8E4Water found in the drip tray
- F8E5Fill valve stuck open
- F8E2Fill valve electrical fault
- H2ONo water detected
- F7E2Wash motor error
- F6E1User interface or main control error
- F6E3Too many suds
- F6E4Float switch error
- F4E2 / F4E3Heating system error
- F3E2Thermistor or OWI sensor fault
- F1E1Control module fault
- F1E2 / F2E2Main control communication error
- F2E1Stuck key or console error
- FAE5 / F10E5Diverter leak
- Sanitize light flashingSanitize temperature not reached
- Control lock light flashingControls locked or asleep
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.