Home › KitchenAid › Dishwashers › F6E3
KitchenAid Dishwasher F6E3 Error Code
Too many suds on KitchenAid dishwashers.
KitchenAidAll KitchenAid dishwasher codes
Sensors picked up foam in the bottom of the tub, and the dishwasher may refuse to fill until it's gone. The usual causes are the wrong soap (hand dish soap, laundry detergent), too much dishwasher detergent, or a rinse aid cap left off.
Compatible models
KitchenAid's suds article covers its dishwashers as a group; no model numbers are given.
Also shown as
No other codes are listed for this fault.
Difficulty
Most people can clear this one at home with simple checks.
Not sure you are reading the code right? See how to read KitchenAid dishwasher codes.
How to fix KitchenAid F6E3
Scoop out the foam
Look in the tub bottom. Use a plastic cup to bail out as much foam as you can, and take the dishes out.
Knock down the rest with cooking oil
Pour 2 to 3 tablespoons of vegetable oil into the tub floor. It flattens the remaining suds.
Run two empty cycles
Run one full cycle with no detergent and no dishes, then a second with detergent in the cup. Check the rinse aid cap is screwed down before you start.
When to call a technician
If you get F6E3 with the right detergent and no visible foam, a sensor may be misreading and a technician should look at it.
Parts linked to F6E3
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
- detergent dispenser
Order parts by your full model number so they fit.
Frequently asked questions
Which KitchenAid models show the F6E3 code?
KitchenAid's suds article covers its dishwashers as a group; no model numbers are given.
Can I fix KitchenAid F6E3 myself?
Usually, yes. Most F6E3 problems clear with simple checks you can do at home. Start with the first step above: scoop out the foam.
Other KitchenAid dishwasher codes
- F9E1Long drain (water not pumping out)
- F9E2Drain motor error
- F8E4Water found in the drip tray
- F8E5Fill valve stuck open
- F8E2Fill valve electrical fault
- H2ONo water detected
- F7E2Wash motor error
- F6E1User interface or main control error
- F6E4Float switch error
- F4E2 / F4E3Heating system error
- F3E2Thermistor or OWI sensor fault
- F1E1Control module fault
- F1E2 / F2E2Main control communication error
- F2E1Stuck key or console error
- FAE4 / F10E4Diverter valve error
- FAE5 / F10E5Diverter leak
- Sanitize light flashingSanitize temperature not reached
- Control lock light flashingControls locked or asleep
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.