Home › Electrolux › Washers › EH0
Electrolux Washer EH0 Error Code
Power supply problem on Electrolux washers.
ElectroluxAll Electrolux washer codes
A power supply problem. Electrolux uses EH0 and similar codes for it but gives no further detail, so start by ruling out the outlet and the house supply.
Compatible models
Electrolux lists EH0 for its washing machines and washer dryers in general and names no specific models.
Also shown as
May appear as EH0 or EHo.
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read Electrolux washer codes.
How to fix Electrolux EH0
Plug in directly
Unplug the washer and plug it straight into a wall outlet, with no extension cord or power strip.
Check other appliances
Flickering lights or other appliances acting up point to the house supply.
Note it and power-cycle
Write the code down, then unplug for 5 minutes and run a short program.
When to call a technician
An unstable supply calls for an electrician to check the outlet and wiring. If the supply is fine and EH0 persists, call a washer technician.
Parts linked to EH0
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
- Electronic control board
Order parts by your full model number so they fit.
Frequently asked questions
Which Electrolux models show the EH0 code?
Electrolux lists EH0 for its washing machines and washer dryers in general and names no specific models.
Can I fix Electrolux EH0 myself?
Only the basic checks. You can safely try the steps above, but EH0 usually points to a part or fault that needs a technician.
Other Electrolux washer codes
- E11Water supply problem or slow fill
- E21Washer is not draining properly
- E30Water pressure sensor problem
- E40Door lock problem
- E50Motor problem
- E60Heating problem
- EF0Leak, too much foam or unbalanced load warning
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.