Home › Maytag › Dryers › F7 E1
Maytag Dryer F7 E1 Error Code
Motor system error on Maytag dryers.
Something is wrong with the drive motor circuit. Maytag names the motor, the control or the wiring between them. A drum stuffed too full, or an item jammed between the drum and the front panel, can also make the motor struggle.
Compatible models
Maytag doesn't publish a model list for F7 E1; Sears PartsDirect lists F-26 for Maytag Bravos dryers.
Also shown as
Maytag Bravos dryers show F-26 for a drive motor failure; Sears PartsDirect says to check the wiring between the control board and motor before replacing the motor.
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read Maytag dryer codes.
How to fix Maytag F7 E1
Take out part of the load
Unplug the dryer, remove some clothes if the drum is packed, and run a hand around the drum edge to find anything caught, such as a sock or a bra wire.
Reset and listen
Breaker(s) off for one minute, then on. Start a Timed Dry and listen for a smooth, steady tumble.
When to call a technician
If F7 E1 comes back, or you hear grinding or smell hot plastic, stop using the dryer and have a technician test the motor and its wiring.
Parts linked to F7 E1
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Step-by-step guides for this problem
- Dryer Making Noise? What Squeaks, Thumps and Rumbles Mean
A high squeal from the bottom of the dryer is usually the idler pulley, a steady thump is often a flat-spotted drum roller or a worn belt, and grinding at the front points to worn drum glides or felt seal.
- Dryer Won't Start? Door, Breaker, Fuse and Switch Checks
Most dryers that won't start have a door that isn't fully latched, a start button that wasn't held for 2 to 5 seconds, a control lock that's on, or a tripped breaker.
- How to Replace a Dryer Belt: Step-by-Step With Idler Routing
If the motor runs but the drum doesn't turn, or the drum spins with no resistance by hand, the belt has almost certainly broken or slipped off the idler pulley.
Frequently asked questions
Which Maytag models show the F7 E1 code?
Maytag doesn't publish a model list for F7 E1; Sears PartsDirect lists F-26 for Maytag Bravos dryers.
Can I fix Maytag F7 E1 myself?
Only the basic checks. You can safely try the steps above, but F7 E1 usually points to a part or fault that needs a technician.
Other Maytag dryer codes
- AF / F4 E3Airflow restricted: check the lint screen and vent
- PFPower failure interrupted the cycle
- L2 / F4 E4Low or missing line voltage on an electric dryer
- ERRDoor isn't closed and latched
- F2 E1A control panel button is stuck
- F2 E4 / F2 E5Control panel internal fault
- F1 E1Main control board fault (motor relay)
- F1 E3 / F1 E4Control unit or wiring problem
- F3 E1Exhaust thermistor failure
- F3 E2Moisture sensor failure
- F3 E3Inlet thermistor failure
- F4 E1 / F4 E2Heater relay failure
- F6 E2 / F6 E3Communication failure between boards
Last reviewed 2026-10-20. Codes and steps can vary by model; check your owner's manual.