Search

Home › Samsung › Washers › LC

Samsung Washer LC Error Code

Water leak or water level problem. What it means, which models show it, and how to clear it, easiest fix first.

SamsungAll Samsung washer codes

LC
Moderate DIY

The washer has detected moisture outside the tub, or the water level is falling during the wash or rinse when it should hold steady. Typical causes are a leaking hose connection, a drain hose that is siphoning water out, or excess suds. Less often, the water level sensor itself has failed.

Compatible models

Samsung doesn't publish a model list for this code; it appears on Samsung washers with a digital display. Check your owner's manual.

Also shown as

Also shown as LE, LC1, 1C, 1E, 1 1C, or 1 LC. On some models LE or LC points to a leak or dropping water level, while 1E or 1C points specifically to a failed water level sensor, in which case the leak checks below are unlikely to help.

Difficulty

Start with the safe checks below; a worn part may need replacing.

Safety first: unplug the washer (or switch off its breaker) before touching filters, hoses or panels. If you smell burning or gas, or see water near the outlet, stop and call a professional.

How to fix Samsung LC

  1. Look for leaks

    Unplug the washer and turn off the water. Check the floor and the back of the washer for drips, then tighten any loose fill-hose connections and replace hoses that are cracked or bulging.

  2. Check the drain hose

    Make sure the drain hose is not kinked and goes only 6 to 8 inches into the standpipe. A hose pushed too far down can siphon water out of the tub. Do not remove the screw holding the hose bracket to the back of the washer.

  3. Clear excess suds

    Run one or more empty rinse cycles with no detergent or softener until no suds remain, then see whether the code returns. Use only HE detergent in the recommended amount going forward.

When to call a technician

If you cannot find a leak and the code keeps coming back without suds, the tub, an internal hose, or the water level sensor may be at fault and a technician should take a look.

Parts linked to LC

These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.

Order parts by your full model number so they fit.

Frequently asked questions

What does LC mean on a Samsung washer?

The washer has detected moisture outside the tub, or the water level is falling during the wash or rinse when it should hold steady. Typical causes are a leaking hose connection, a drain hose that is siphoning water out, or excess suds. Less often, the water level sensor itself has failed.

Which Samsung models show the LC code?

Samsung doesn't publish a model list for this code; it appears on Samsung washers with a digital display. Check your owner's manual.

Can I fix Samsung LC myself?

Often. The first steps above are safe checks a homeowner can do. If they don't clear LC, the cause is likely a worn part that needs replacing.

What if LC keeps coming back?

A code that returns after a reset and the checks above usually means a part is wearing out. Note when LC appears (which cycle, how often) and have your model number ready; it helps a technician bring the right part on the first visit.

Other Samsung washer codes

Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.

Sources we checked