Home › Frigidaire › Dryers › E64
Frigidaire Dryer E64 Error Code
Heating element circuit open on Frigidaire dryers.
FrigidaireAll Frigidaire dryer codes
AppliancePartsPros says E64 usually means the heating element circuit is open. The coil may be broken or burned through, or a wire to it has come loose or failed, so the dryer heats weakly or not at all and loads take much longer.
Compatible models
AppliancePartsPros covers Frigidaire dryers in general and doesn't name models or series. Check your owner's manual or tech sheet.
Also shown as
Not listed in the Sears PartsDirect Frigidaire table. The AppliancePartsPros guide works through heater coil checks, which fit electric dryers; confirm with your model's tech sheet.
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read Frigidaire dryer codes.
How to fix Frigidaire E64
Check both breakers
Before assuming the element is gone, flip the dryer's double breaker off and on. A half-tripped breaker gives the same no-heat result.
Unplug for 5 minutes and retry
Restore power, run a heated cycle and feel for warm air at the outside vent within 5 to 10 minutes.
When to call a technician
Testing the element means removing cabinet panels and checking coils and wiring with the dryer unplugged. Book a technician; if the element tests good, the control board may be the fault.
Parts linked to E64
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Frequently asked questions
Which Frigidaire models show the E64 code?
AppliancePartsPros covers Frigidaire dryers in general and doesn't name models or series. Check your owner's manual or tech sheet.
Can I fix Frigidaire E64 myself?
Only the basic checks. You can safely try the steps above, but E64 usually points to a part or fault that needs a technician.
Other Frigidaire dryer codes
- E4ADry time ran too long
- E5BNo heat detected
- E8CHigh-limit thermostat tripped too often
- E68Stuck key on the control
- E24 / E25Thermistor shorted or open
- E10 / E11 / E12Control board communication error
- EAFElectronic control board failure
Last reviewed 2026-10-20. Codes and steps can vary by model; check your owner's manual.