Home › Electrolux › Dryers › E70 / E71
Electrolux Dryer E70 / E71 Error Code
Temperature sensor problem on Electrolux dryers.
ElectroluxAll Electrolux dryer codes
The control can't trust its temperature sensor reading. Electrolux UK describes E70 as a temperature sensor problem; Sears PartsDirect lists E71 as a temperature sensor failure and checks the sensor, then the harness, then the main board.
Compatible models
Electrolux tumble dryers (UK support, E70) and the Electrolux compact condensing dryer (Sears PartsDirect, E71).
Also shown as
E70 comes from Electrolux's UK support pages; E71 (written Ex71) from Sears PartsDirect's table for the compact condensing dryer.
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read Electrolux dryer codes.
How to fix Electrolux E70 / E71
Unplug for two hours
Electrolux's reset for E70 is to leave the dryer unplugged for two hours and then plug it back in.
Keep it off if the code returns
Electrolux says not to use the dryer until it's repaired. Leave it unplugged and note the code for the engineer.
When to call a technician
A sensor or board fault needs an approved service technician; the sensor sits inside the cabinet.
Parts linked to E70 / E71
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
Order parts by your full model number so they fit.
Frequently asked questions
Which Electrolux models show the E70 / E71 code?
Electrolux tumble dryers (UK support, E70) and the Electrolux compact condensing dryer (Sears PartsDirect, E71).
Can I fix Electrolux E70 / E71 myself?
Only the basic checks. You can safely try the steps above, but E70 / E71 usually points to a part or fault that needs a technician.
Other Electrolux dryer codes
- E45Door open
- E21 / E22Condensate drain pump fault
- E31 / E32Humidity sensor failure
- E52 / E54Motor overheated or drum jammed
- E51 / E53Drive motor failure
- E5AMotor inverter board overheated
- E57 / E58 / E59 / E5d / E5E / E5F / E5HMotor drive (inverter) fault
- E62 / E63 / E64Compressor fault (heat pump models)
- E9EControl panel buttons not responding
- E91Control panel communication failure
- E92 / E98Control panel doesn't match the main board
- EH1 / EH2 / EH3 / E5CPower supply out of range
- E83 / E86 / E87 / EH4 / EHd / EHE / EHF / EF6Main control board failure
Last reviewed 2026-10-20. Codes and steps can vary by model; check your owner's manual.