Guides Search

Home › Washers › Parts › Heating element and temperature sensor

Washer Heating element and temperature sensor: What It Does and Signs It's Failing

Many front-load washers heat their own water with an element in the bottom of the tub, reached through the back access panel. The water temperature sensor (a thermistor) usually sits in that heater assembly. On some machines the sensor is built into the inlet valve instead, where it helps balance the hot and cold coming in.

Who should replace it

Handy homeowners can replace it

Related codes

11 error codes on this site point to this part.

How it works

The control turns the element on and watches the sensor until the water reaches the setting. The sensor's resistance drops as the water warms; on one Whirlpool front-loader it reads about 14.8K ohms at 68°F (20°C) and 9.8K ohms at 86°F (30°C). A dead element or an out-of-range sensor makes the heat step stall or time out.

Signs it is failing

Heater, heater-control and temperature sensor codes all point here. Heating at the wrong time can also come from the heater relay on the control board.

Can you replace it yourself?

Unplug the washer and take off the back access panel to reach the heater assembly. On the Whirlpool front-loader in AppliancePartsPros' guide, the sensor comes out after you loosen a 10 mm nut on the assembly, and it's sold apart from the element. If the breaker trips when the wash starts heating, stop using the washer and have a technician check it.

Always unplug the washer or switch off its breaker before opening any panel, and turn off water or gas where relevant.

Buying the right part

Elements differ in wattage and size between models, and the sensor is usually sold on its own.

Error codes linked to the heating element and temperature sensor

Last reviewed 2026-10-19.