Home › Frigidaire › Dishwashers › iC0
Frigidaire Dishwasher iC0 Error Code
Electronic control problem on Frigidaire dishwashers.
FrigidaireAll Frigidaire dishwasher codes
The electronic control system has flagged a fault in itself. There's no plumbing check for this one.
Compatible models
Comes from the FGID2479SF and FPID2498SF use and care manuals; Frigidaire publishes no wider list.
Also shown as
No other codes are listed for this fault.
Difficulty
Try the basic checks, but the usual fix is a technician's job.
Not sure you are reading the code right? See how to read Frigidaire dishwasher codes.
How to fix Frigidaire iC0
Do a long reset
Switch off the breaker for 5 minutes so the board fully powers down. Then restore power and start a cycle.
When to call a technician
If iC0 shows up again, the control board needs service.
Parts linked to iC0
These are the parts most often behind this code. Tap one to see what it does and the signs it is failing.
- main control board
Order parts by your full model number so they fit.
Frequently asked questions
Which Frigidaire models show the iC0 code?
Comes from the FGID2479SF and FPID2498SF use and care manuals; Frigidaire publishes no wider list.
Can I fix Frigidaire iC0 myself?
Only the basic checks. You can safely try the steps above, but iC0 usually points to a part or fault that needs a technician.
Other Frigidaire dishwasher codes
- i10Low fill detected
- i20Didn't drain completely
- i40 / iF0Clogged filter or sump
- i30Leak or overflow in the base pan
- i50Drain or wash motor problem
- i60Water heating problem
- PFPower was lost
- CL / CdDoor not latched
- Hd / HOHeating water before washing
- Status lights flashing after drainPossible shorted keypad
Last reviewed 2026-10-19. Codes and steps can vary by model; check your owner's manual.